Resources

Installation guides & how-to resources

Step-by-step guides written by our technicians. Open the featured guide below to read it inline.

Programming a Bosch Solution 3000

Alarm systems · Installer · ~35 minutes · 8 steps

Bosch Solution 3000 panelInstaller codeWired or wireless detectorsKeypadProgramming manualPhone line or IP module (optional)

Power down the panel and confirm all detectors and the keypad are wired correctly.

Power the panel on and enter installer programming mode with the installer code.

Assign each zone to a detector and set the zone type (entry/exit, interior, 24-hour).

Set area names and walk-test each zone to confirm it reports correctly at the keypad.

Program user codes and assign area access per user.

Change the default installer code before handover — leaving it default is a common audit failure.

Configure reporting (monitoring station or app notifications) if required.

Set entry/exit delay times to suit the property layout.

Run a full walk test with the system armed to confirm every zone and siren response.

NVR first-time setup walkthrough

Crimping an RJ45 connector

Pairing AX Pro wireless sensors

Talk to our team about a licensed technician for your site. Contact us →